Clean a 4WD after the Flinders Ranges or an outback run from the bottom up and from the outside in. Rinse the underbody and wheel arches first, then wash the body, then deal with the seals, vents and cabin where the red dust has crept into everything. And book it in with a mechanic to check the air filter and whatever else the trip may have been hard on.
That is the short version. The long one follows, because outback dust is not ordinary dirt.
Why red dust is so stubborn
The red dust you pick up on corrugated tracks is almost as fine as talc. It rides air currents into places normal road grime never reaches: behind door seals, into tailgate hinges, through gaps in the dash, inside the fridge slide. It is also mildly abrasive, so wiping it off dry scratches paint, glass and gloss black trim. And it stains. Pale upholstery, roof linings and white paint can take on a pinkish tinge if the dust gets wet and dries in.
So the rule is water and lubrication before any contact, and patience with the parts you cannot see.
Step one: underbody and arches
Mud dries hard on the chassis rails, inside the arch liners and around the suspension. Left there, it holds moisture against metal and adds weight. Soak it first with plenty of water to soften it, then rinse with a pressure washer from a sensible distance, working along the chassis and up into the arches. Do not aim a concentrated jet at wheel bearings, electrical plugs, breathers or the radiator core.
If you have crossed salt lakes or driven beach tracks, the underbody rinse matters even more, because salt left in seams is a corrosion risk.
Step two: the body
Once the heavy stuff is gone, foam the vehicle and let it dwell to loosen the remaining film. Rinse again. Then hand wash with plenty of shampoo and a clean mitt, rinsing the mitt often. Insects from long highway runs at dusk can coat the front end, and the advice in removing bugs and road tar applies here.
Dry it and inspect the paint closely. Branch scratches from narrow tracks, often called pinstriping, usually sit in the clear coat and frequently polish out. Deeper ones may need a panel shop.
Seals, hinges and door shuts
Open every door, the bonnet and the tailgate. You will find a red line along each seal and a fan of dust across the jambs. A soft brush, a damp microfibre and some patience shift it. Wipe the rubber seals clean and give them a rubber protectant afterwards. Rear barn doors and tailgates on older 4WDs are notorious for letting dust in, so go over the cargo area carefully.
Step three: inside
Take everything out: recovery gear, fridge, drawers, swags, the lot. Recovery gear deserves its own attention. Snatch straps and soft shackles that went away muddy should be rinsed in fresh water and dried completely out of direct sun before storage. Follow the manufacturer's guidance for inspecting them, and replace anything damaged.
In the cabin, blow out the vents with compressed air while the fan runs on fresh air, then vacuum thoroughly. Fabric seats will need a proper extraction clean if the dust has worked deep into them. Do not soak a pale roof lining. That is how dust stains spread and how the glue behind it lets go.
What to leave for the mechanic
Some of what an outback trip does is not a cleaning matter at all. The air filter may be choked with dust. Cabin filters, breathers, wheel bearings, brakes and suspension bushes all take a pounding on corrugations. A qualified mechanic is the right person to check these after a big trip, and it is far better done before the next one than discovered halfway along the Oodnadatta Track.
If you would rather hand the cleaning over, our full detail covers the outside, the seals and the cabin. For a sense of why larger vehicles take longer in general, see detailing an SUV or 4WD.